Injection moulding

Melt casting technique for processing thermoplastic hot melts.

Injection moulding

With this innovative process, which is already suitable for small series from 100 pieces and more, a variety of structural possibilities can be realised:

  • Overmoulding of inserts (insert moulding)
  • Manufacture of moulded parts, such as cable bundling or strain relief
  • Overmoulding of plug connections
  • Filling housing (potting)

The advantages offered:

  • Gentle low-pressure method, therefore no component deformation
  • Absolutely waterproof (I P 68)
  • No additional cable strain relief necessary
  • Temperature resistant from -40°C to +150°C, if necessary UV-resistant
  • Optimal adhesion to all common cable and connector substrates
  • Long service life
  • Long service life high level of resistance to chemicals, fungi and decay
  • Very good cost-benefit ratio
  • High level of process reliability
  • Self-extinguishing

System solution:

  • Design of the moulded part
  • Development of the tool form
  • Creation of sample parts
  • Creation of series parts

Simeto Kabelsysteme GmbH
Zwotaer Straße 6
D-08248 Klingenthal
Phone +49 37467 2818 0
Fax +49 37467 2818 25
E-mail: info(at)